Austin International, Inc's engineering department is developing new products to support electric metering every day. The Sentry product line of data recorders, totalizers, isolation relays, demand controllers and software products is a valuable set of tools used by businesses and utilities world wide to monitor and control energy usage. In addition to the already cost effective products and systems available through its electronics division, Austin International, Inc. now provides it's customers with the ability to access recorded data 24 hours a day.
Sentry 11
Provides maximum protection from transient surges that often occur as a result of lightning, line surges & capacitor tripping. The Sentry 11 provides clamping voltage of +/- 209 volts peak with surge protection up to 3 KV. Click here to view a PDF of the sentry 11 for more information.
$25 Each
Sentry 20
Provides isolation between an originating contact closure that requires a low voltage/current contact rating and one or two end devices. Typical end devices are customer-owned energy management equipment, recording equipment and redundant metering equipment. Click here to view a PDF of the sentry 20 for more information.
$140Each
Sentry 30 Isolation Relay
Accepts one Form C open collector or relay contact input and provides up to three isolated bistable outputs. The bistable output prevents propagation of contact bounce from the input relay and also eliminates extraneous pulses during power up or power down.Click here to view a PDF of the sentry 30 for more information.
Provides a highly effective solution for total energy control. The DMS 2100 is an affordable means of monitoring energy consumption, reducing or avoiding peak demand charges and lowering usage cost.
The Sentry 2K-3S adapter has been designed to replace self contained 400/480 Amp
K Base meters with a form 3S electronic meter without degrading the metering
installation. The adapter is completely self contained with very accurate 400:5 Current Transformers with a rating factor of 1.5, and by-pass switch that shorts the CT’s when the meter is not in the circuit.
The Sentry 16K/9S-1 adapter has been designed to replace self contained 600 Amp K Base meters with a form 8S/9S electronic meter without degrading the metering installation. The adapter is completely self contained with very accurate 400:5 Current Transformers with a rating factor of 1.5, and by-pass switches that short the CT’s when the meter is not in the circuit. Click here to view a PDF of the sentry 7000 for more information.
$250Each
Cleans up to 800 meter bases per 8-hour shift. Removes all but the toughest grease from stabs. Environmentally friendly uses clean water e cleanonly. Uses 120 volt - no special wiring needed. Stainless steel construction resists corrosion. Brush life is up to 30,000 meter basings.Click here to view a PDF of the sentry 7000 for more information.
$5000Each
Call us to order this item!
Sentry 850
Lightweight and easy to use. Battery operated with automatic power-saving cut off. Weatherproof. Excellent field tool for troubleshooting ERTs and ERT compatible devices. Reads the Invensys Icon Meter and Schlumberger R300, R200 and Centron with ERT module. Click here to view a PDF of the sentry 850 for more information.
